Description:
1.High quality with competitive price2.With CE, ISO, FDA certificates
3.OEM order is accepted
Dental materiafor AllPurpose Light Cure Composite
Material Instruction:
Flowable Light Cure Composite (FLC) consists of meth methacrylatemonomers, inorganic fillers and nanoparticles. Due to its greatflowable and thixotropic properties, it can be used for a smallarea where could not be reached by applying other composites. Thefiller loading is about 34% by volume. The particle size variesfrom 0.03 to 1microns
Composition:
UDMA
BisGMA
1,6-Hexanedioldimethacrylate
Inorganic filler: Bariumglass, strontium glass, nano-silica
Photoinitiator
Stabilizer
Pigments
Appearance:Light yellow viscous paste
Indicationsfor Use:
Ideal for Class III, class V and some smaller non-stress-bearingclass IVrestoratives
Pit andfissure sealant
In-layand on-lay
Porcelainrepairs
Instructions:
1. Preparation: isolate preparetooth.
2. Cleaning: rinse the preparation withwater.
3. Drying: gently air dry until there is novisible water. Do not allow enamel or dentin to dry for anexcessive period of time.
4. Applying Medican Self-EtchingAdhesive(SEA): dispense 1-2drops of SEA into a mixing well, applyenough SEA to the entire preparation with a little brush until ashiny surface is achieved and then wait for 10 seconds(SEA shouldnot be applied to much). Use a gentle stream of air to evaporatethe solvent for 5 seconds. (if using a non self-etching adhesive,an etching step should be used according to the manufacturer’sinstruction).
5. Cure:Light cure for 20seconds at 500±50mW/CM2. Keep the distance to exposuresurface less than 4mm.
6. Applying Medican Flowable Light CureComposite (FLC): place suitable FLC into cavity preparationfollowing by 30s light cure. The depth of cure is about 2.5mm for20 seconds cure (In order to reduce shrinkage stress, for a largecavity, an increment filling is recommended. In general, 1-2mmincrements are placed into cavity preparation from different sidesand the restoration is built incrementally. Each increments islight cured for 20 seconds.
7. Finishing: after light cure, adjustrestoration.
8. Polishing: usepolishing strip or disc to polish the surface
Warning:
Do not use this product for patient who is allergy to methylmethacrylate. Do use this product with any material containedeugenol.
Attention:
To anexposed pulp, a pulp capping material such as Calcium hydroxidemaybe used before using this products.
Storage:
Store at25 or less in a cool and dry place and avoid direct sun exposure.Recap the syringe after use
Shelflife:2 years
Ourfactory:
