2 Screw,The Take-out Robot with 3 Station Cooling,only 9S.

Demark 48,72,96 cavities pet preformsystem@(injectionmoldingsystem@injectionmoldingmachine@petpreformline@) uses a new part cooling andhandling system, which features:
    1.  Cooling on the inner surface of thepreform without using compressed air, unlike most post-mold coolingsystems which only cool the outer surface
    2.  Optimized cycle utilization -being mounted on the moving platen, the cooling systemremains active for up to 85% of the overall cycle.

Demark pet preform injection molding systems areavailable from 280 to 500 tonnes (2800 to5000 kN) and upto 96 cavities.

Demark pet injection systemsoffer:
    1.  Fastercycles(9s)
    2.  Reduced energy consumption
    3.  Smaller footprint 
    4.  Improved repeatability 
    5.  Rapid set-up

Features:
    1.  Two state plasticizing enables plentyinjection quantity;
    2.  Take out plate with three workingposition insures sufficient cooling time and shorter cycletime;
    3.  High quality parts and accessories fromworld famous brands enable higher speed and precision;
    4.  Special screw design increases torquewhile brings down shear force to avoid degradation;
    5.  Accumulator from world reputablemanufacture increases performance while brings down powerconsumption;

Reflex Platens
Reflex platens distribute clampforce evenly across the platen face.
Reflex platens:
    1.  Allow for 10-30% lower clamptonnage 
    2.  Decrease mold wear 
    3.  Improve part quality
 
Injection Units
demark systems offer bothreciprocating screw (RS) and two-stage injection units. RS unitsoffer the performance required for many PET applications whiletwo-stage is appropriate for higher throughput applications.
 
Controls
DMK-based controls manage allfunctions of our PET production systems, with optional packages tointegrate auxiliaries and downstream part handling equipment.Advantages include:
    1.  Faster cycle times 
    2.  Improved shot-to-shotrepeatability 
    3.  Remote connectivity throughServiceNetlink 
    4.  Control of molding system andauxiliaries from a single interface
 
Linear Bearings
Linear bearings support the moving platen directly on the machinebase. This design reduces mold wear by improving platen alignmentand perpendicularity, and provides a grease free moldingenvironment.