l  High power, high current, high-performance powerconversion circuit. The iCharger series usesadvanced Synchronous buck-boost DC/DC convertertechnology with an output conversion efficiency that can reach over90%. This not only saves power and reduces heat build up but alsomakes the charger more compact and conveniently mobile.

l  Input power with 4mm bullet connectors (25A) butt-weldedalligator clips and wide input voltage ranges from 10V to 28V. Theoutput power can be adjusted to align with the available inputpower, thus preventting input current overload and protecting theDC source.

l  The iCharger series can be used withthree types of Lithium batteries - LiPo, Lilo, LiFe - and has afully integrated cell balancer.

l  Internal temperature sensor and temperature controlledautomatic cooling FAN controls the internal temperature andprovides intelligent protection. When the internal temperature isover 60â????(140 oF), the output power is automaticallyreduced by 25%. If the temperature exceeds 65â????(149oF) the charge cycle is stopped.

l  Convenient set of 10 battery profile memories that canbe saved and loaded by number.

l  2x16 backlit LCD screen that provides rich informationincluding active mode, current, voltage, total charge (mAh),charging time and temperature etc.

l  Various charging/discharging settings and cycles to meeta wide range of customer needs. For Lithium batteries: balancecharging, normal charging, fast charging, storage, discharging,ext-discharging, charge/discharge cycling, and battery monitoring.For NiCd/NiMH batteries: charging-auto, charging-manual,discharging, charge/discharge cycling and forming charge. For Pbbatteries: charging and discharging.

l  Up to 300w unique regenerative discharge capability.Regenerative discharge takes most of the output battery’s energyand puts it back into the input battery, which is not the same withthe traditional methods of discharge to deplete that energy in theform of heat across a transistor. That is, when you discharge yourLiPo for storage, you will be re-charging your Lead Acid inputbattery. The amount of current and voltage that your input batterycan accept limit the total amount of power that you can achieve, or300W, whichever is lower.

l  Unique Lithium battery expanding discharge program. Whenyou connect the external capacity resistance, you can use it as themaximum discharge power capacity—600W (@30V/20A).

l  Unique Lithium battery Monitor program. When you useother equipment to charge or discharge a Lithium pack, you can usethe iCharger to monitor the per-cell voltages,battery temperature and process time. If any individual cellappears over-charged or over-discharged or the pack is too hot orthe process has gone on for too long, the iChargerwill generate an alarm sound and the related information willblink.

l  Electric motor test mode can be used to run-in electricmotors, test motor parameters and performance, check tolerancesetc.

l  Foam-cut drive. In this mode, the charger acts as aconvenient power supply for a hot wire foam cutter.

l  Battery interior resistance measurement. TheiCharger can not only measure the internalresistance of the battery pack, and also can measure the per-cellinternal resistance (only available for lithium battery).

l  Perfect protection. The iCharger hasprotection for reversed polarity (input or output), low inputvoltage, battery temperature, charging capacity and timeoverrun.

l  iCharger 206B has a 16Mbit flashstorage, which can log offline charge and discharge data in 36hours.

l  Support upgrading the hardware program by USB port. TheiCharger also support the “logview” software andcan display, plot and analyze the charge and discharge data by it.(See detail information about logview in thefollowing website: http://www.logview.info)