8000/9600mAh ultrathin external battery pack for ipad2/3

Product details:

Introduction:
This product is suitable for iPad2,i Pad3. In addition to being asuper battery life of portable back-up battery pack, can also beused as the i Pad protective cover, bring to your iPad strongmomentum and excellent console protection.
Built-in large capacity rechargeable lithium battery (8000mAh), Theconsole for the i  Pad provides the most about 5 hours ofbattery life use of time.
Pad original AC adapter with the battery pack charging to thesaturation takes about 4 hours.
With 4 LED battery indicator and a battery test switch, real-timecheck the battery pack power, use more convenient.
With 1pc Big 4pin turn the small 5pin USB adapters.

Electrical parameters:
1. Input voltage: 5V;
2. Input current: ≤ 2.1A;
3. Quiescent current: <100μA;
4. Output voltage: 5V;
5. Output current: ≤1.5A

Battery indicator:
Press the battery test switch, power on, LED light indicates thatthere is 5V output voltage output. Then press the test switch ≥ 3seconds, the power is off.
Turn on the power, if no external load, 3 minutes after the batterypack will automatically enter standby mode.
Press the battery test switch, such as the battery pack charge morethan 90%, while the four LED light will light up; such as thebattery pack power is greater than 70% and less than 90%, thefirst, second and third LED lights also light cases; If the batterypack power greater than 50% and less than 70%, while the first andsecond LED lights also light up; when the battery pack power isgreater than 30% and less than 50%, the first LED lights ; When thebattery pack capacity is less than 30%, while the four LED lightsflash, prompting the user needs to be charged.

User Manual:

1. As shown in Figure, place the i  Pad console into thebattery pack, and then charge the battery pack on the switch to ON,the battery pack began to charge the console, i  Pad chargingicon will prompt the appropriate . After fully charged, pull thecharging switch to OFF position, then take out i  Pad from thebattery pack.
2. supporting the battery pack through the USB converter cableconnected to the i  Pad original AC adapter, then connect toAC power adapters, you can recharge the battery pack. Charging forthe water four LED display, charge saturation, the four LED turnlit display. Charging process of charging the switch to anyposition shall not affect the charging process.
3. When the battery pack to charge the console for the i  Pad,they can be connected to USB converter cable i  Pad originalAC adapter, Priority will be given at this time for charging thebattery pack.
4. The iPad host into the battery pack, and through supporting theUSB converter cable to the PC, you can be data transfer betweeniPad and PC.

Attentions:
1. IPad through the battery packwill access the PC, only for i  Pad and PC data transfer, cannot charge for Pad.
 2. Charging, the battery pack will begin to heat, this isnormal, for the prevention of overheating, ventilation and shade inthe battery pack charged.
 3. Please do not use chemical solvents to clean thisproduct.
 4. Please do not attempt to disassemble, throwing, smashing,or cut with a sharp object, designated battery pack.
 5. Keep the battery pack away from heat, fire place, andavoid direct sunlight.
 6. Please do not place the battery pack stored in damp orinto the water.

Pictures:

8000/9600mAh ultrathin external battery pack for ipad2/3