Product details
Technical Feature
1. 250 MHz MIPS Processor(350 MIPS)
2. Linux Operating System
3. 1 card reader
4. MPEG2 hardware decompression
5. DVB-S, DVB-C, DVB-T
6. V. 24/RS232 interface
7. 100Mbit Ethernet interface two-way
8. 2 LED instructions
9. Unlimited number of TV / radio channel list
10. Channel switching time less than 1 second
11. Full automatic service scan
12 EPG (Electronic Program Guide)
13. Support for DiSEqC
14. Multi-lingual
15. The number of bit-stream output SPDI / F interface
16. European Scart plug (software control).
17. Skin-support external 12V power supply
Technical Data
IF input: 950-2150 MHz
AC + / - 3 MHz
75 ohm input impedance
QPSK
Signal Level - 65 dBm...- 25 dBm
The scope of input symbol rate
Signal-to-Noise12 dB maximum
2...45M SCPC / MCPC
Mother of the first socket F
Forward error correction
75 ohm input impedance
1/2, 2/3, 3/4, 5/6, 7/8automatic
Video decoder:
Video Compression MPEG-2 and MPEG-1 compatible
PAL G / 25 Hz standard
Video proportion of 4: 3 / 16: 9 (automatic)
Audio decoder:
MPEG-1 & MPEG-2 Layer I and II
Frequency: 32 kHz, 44.1 kHz, 48 kHz, 16 kHz,
22.05 kHz, 24 kHz
Stereo
Analog output
Output Level L/R 0, 5 Vss on 600 OhmTHD > 60 dB (1 kHz)
Crosstalk < -65 dB
Digital output
Output Level 0.5 Vss on 75 Ohm
Sampled Data Filtering 32 kHz, 44.1kHz, 48kHz
S/PDIF- optical output (AC3)
Video parameters
Input FBAS 1 Vss + / - 0.3 dB on 75Ohm
Teletext filter: ETS300472standard
European Scart plug:
Output: FBAS, RGB, S-VHS
RS232 interface:
Bitrate 115, 2 Kbit / s maximum
Pin SUB-D-9
Firmware upgrade
Ethernet port:
I firmware upgrade network
LNB power and polarisation:
LNB Current 500mA maximum. Short-circuit protection
Vertical polarization LNB voltage <14V without load, > 11.5V (400mA)
Horizontal polarization LNB voltage <20V
Without load, > 17, 3 V (400mA)
LNB power-down standby
Receive control
DiSEqC 1.0/1.2 SAT location / SAT SelectDiSEqC - motor control Power consumption: <10W / 12V
External power supply:
Input: 110-240V AC / 50-60Hz / 0, 6 A
Output: 12V = / 1A
