MOQ:10
Quantity:1
Alarm display standspecification:Size: 130* 140* 110mmApplicable products: ipad ,PC table,cell phone,MP3, MP4,GPS and other digital productsColor: Silver whiteMaterial:AcrylicStandby time: 300daysCharging voltage :100-240VOutput voltage: 5V (for most digital products,charging theft)Applicable environment: Temperature -40 to 60degrees indoor flat DesktopWeight: 380g
Product features
1) The alarm function: if cut down the probe cable or separate probe and exhibits, system will immediately report the police.
2) super long standby: charging full one time can last 12monthes
3) Multiple disassemble alarm: remove any part of device can report the police
4) The charging function: system can provide a set of charging voltage 5 v, charging for digital products.
5) Remote control switch, the infrared digital remote control function of each port alarm sensor automatic detection reset function
Method of use:
1) remove the adhesive protective film at the bottom of the alarm device and fixed it on the clean and flat table
2) remove the adhesive protective film at the the sensor and put the digital products on it,if the alarm ring one second, show that alarm running normally
3) Connect the power cable on the left of alarm device,the red light on means the charging is start ,if the power full it will automatically shut down
4) If the Blue light on means the alarm did not enter the working state or alarm device broken
5) the factory code is 3, 4, 5.If there is any alarm, please press 3, 4, 5 consecutive key can cancel the alarm sound
Remote control use
1) Change password: from the alarm telephone jack pulled out induction on the right side of the spring line alarm will report to the police. At this time Blue light is flashing
2. Press the password remove alarm then long press the set button for five seconds after hearing 1 ring enter the old password,if insert is correct the alarm will got two seconds long rang ,then put in the new password and then enter three digits long alarm ring at this time for 2 seconds, and then enter the new password again after two new password input is correct ,the alarm will ring 3 sounds means the password was changed success
3. Note: the password for the 3 digits,the new password input must be the same input two intervals of not more than 15 seconds .more than 15 seconds alarm will ring a loud said to modify the password timeout needs according to modify the Settings button of the remote control again
4.Forgot password: remove the alarm from the desktop ,using the paper clip insert at this side of alarm holes and blue light is flashing 3 times means the alarm restore factory state, 3, 4, 5 is the password of the factory status,.
Attention
1. Forbid dismantle any part of the product
2. The built-in battery standby for six months, if the battery power is insufficient, please recharge in time
3. To ensure that the host for normal inspection of each communication port to connect each sensor communication line all keep right
4. To prolong battery life, it is recommended that the exhibition machine normal charging time not more than eight hours,no need to charging long time
5. if the viscose not instable, please don''t continue to use it for your product safety
