Advantages and features of converting steelmaking overall taper oxygen lance are as followed:
1. To increase storage of cooling water in the heat radiation zone of furniture and to improve furniture cooling performance. In the steel-making process, the place which is 4-6 meters from the oxygen lance's nozzle above is working spot, which receives 1200-2000 degree Celsius heating radiation under bad high-temperature environment. Compared with the ordinary oxygen lance, taper body is the place which is 6-8 meters from heat in our taper furniture, which may save more cooling water and optimize cooling performance in higher furniture.
2. To reduce slag hanging and dry slag at the taper surface. In the steel-making process, cooling performance is seriously affected owing to frequent slag hanging and dry slag of the furniture, more worsely, leading to burning lance, burning nozzle, sticking steel and deterioration of oxygen supply. However, as far as taper oxygen lance produced by our company is concerned, whose spots have certain angle conical surface where there are slag hanging and dry slag. In this case, they will fall automatically down from the conical surface because of the steel slag dead load and the good cooling performance of lance furniture even if slag hanging and dry slag phenomenon exist in steel-making process. Thus, there are less slag hanging and the dry slag, even no hanging and dry slag phenomenon.
3. To reduce the replacement frequency of outer pipe of taper oxygen lance, labor intensity of steelworker and steel-making production cost. As a result of the use of taper outer pipe, the cooling performance is obvious, slag hanging and dry slag reduce, burning loss of outer pipe reliefs, service life lengthen, which reduces the replacement frequency of outer pipe of taper oxygen lance, saves resources for steel plants and reduces the production cost.
4. To adapt to high-intensity oxygen supply environment, increase production efficiency, save energy and reduce consumption. As a result of the use of taper outer pipe, the cooling performance is obvious, slag hanging and dry slag reduce so that normal cooling effect of nozzle can be guaranteed and oxygen jet flow can be stirred normally, which is avoided being eliminated by more intense condition in the furnace even if in high-strength smelting environment. This kind of high-intensity oxygen supply can reduce supply time with the practice proving that time of each furnace steel could be shortened by 2-3 minutes; At the same time, it reduces excessive consumption and waste of oxygen, saves energy and lowers production cost of per ton steel.



