Product introduction
Our company has lately produced a new pattern of F01 and F02 Sound & Light Alarm. It is widely used in terminal facilities, especially suitable for fire protection alarm. This product adopted advanced high-pressure gas flash lamp and super-volume bugle made in Germany. Its light, sound and electricity efficiently transfer, the parameter of flash is big and volume of the alarm is strong. It can lead to excellent optical efficiency even though while inputting low voltage of supply power and conveniently choose three kinds of alarm sound (fire engine, ambulance and police vehicle).
The application of F01 and F02 alarm has a very flexible alternative. The requirement of supply power is low and working in a variety range of voltage. It is allowed supplying voltage with larger wave direct current power (or semi-wave transformed supply power). It is a better designed-work point to run by 24V.
Remarks:
(1) The above performance index is tested when the voltage is 24V. Its flash frequency cycle and volume intensity also change accordingly if voltage alters.
(2) This product's flash frequency cycle temporarily is <2 second. We will make corresponding adjust after Fire Administration Department officially promulgate relative policy. We also do appropriate changes as per customers' special requirements.
 
Installation instruction
1First drill two holes in the place of setting (wall). The distance of holes is 60mm, at the same time setting plastic expand plug. (It can tighten with screw if the wall made of wood.)
2Using two screws, fix the base to the wall. The direction is shown in Fig.2. Then draw the wires from the hole in the base.
3Connect the wire as picture 3. Set 3 kinds of alarm sound according to customers' requirements.
4Set the Sound & Light Alarm on the base and fix it with a screw.
Maintenance
1 It is need to inspect the working situation of alarm periodically to make sure that the alarm works normally. Please not take down to repair personally and contact with our company if any abnormality happens.
2 Inspect the cleaning of alarm's surface. Please scrape neatly with soft paper if it has stain.