Model:-
Application
Axial fans :Air heaters,cooling units, heat pumps, evaporators, condensers, electronic equipments.
Centrifugal fans: Blowing air or cooling.
Fans with external rotor motor
Dunli fans with external rotor motor drive offers features such as space saving, compact and attractive design. The motor is fitted within the impeller, which enables the best possible cooling.
100% speed infinitely controllable external rotor motors have extremely low starting currents, the motors can apply to protection class IP54. The windings comply to insulation class B and F., with thermal protector in motor windings as standard for motor protection. The fan can work with ambient temperature from -30 up to 60 Centigrade.
Electrical connection
The motors are fitted with flying lead cable. The electrical connection can be made via an IP54 terminal box, which is supplied loose.
Speed control
Dunli external rotor motors are particularly suited to 100% speed control by voltage variation. The best results are obtained by using auto-transformers. If the voltage variation is by electronic controller(silicon controlled velometer for example) it is vital that the wave form cannot damage the motor winding. If the motor speed is controlled by frequency variation (an inverter for example) it is equally vital that the rate of rise of voltage and peaks of voltage wave form should be controlled and filtered before reaching the motor. Dunli is able to produce three-speed motors with speeds to suit the application.
Impeller
Axial fans: Blades are made of steel plate, power coated in black, against eroding well, welded directly to the rotor of the external rotor motor and the motor impeller is balanced dynamically and statically according to quality G6.3.
Centrifugal fans: impeller is made of galvanized steel plate, aluminium sheet or plastic, mounting motor by a flange.
Guard grills
Dunli guard grills are made of steel wire, power coated in black, serving as finger protection and for mounting the fan onto the inlet ring.
Inlet ring
Axial fans: Inlet rings are made of steel plate, power coated in black, against eroding well, provided to suit customers individual requirements.
Centrifugal fans: Inlet rings are made of galvanized steel sheet, against eroded well.
Air flow curves
Our air flow curves are tested at air density of
Noise levels
Noise is sound pressure level, measured one meter from the air inlet.
Life expectancy
The Dunli motors and fans described in this catalogue are fitted with ball bearings for use in any mounting attitude. L10 life expectancy is between 30000 and 50000 hours, depending on the application and ambient conditions
Available on request
Different voltages and frequencies/Longer cables/Better bearings/Special demands




