Oil-air lubrication is a process that makes the mixed lubricant and compressed air formed a turbulent flow and jetted to the lubricating points by fine and continuous oil droplets.
Oil-air lubrication is applicable for rolling bearings, open gears, chains, tracks, wheel flange lubrication, especially suitable for high-temperature, high-speed, heavy-load, ultra-low speed and by the water or other chemical hazards fluid erosion occasions.
1)HSH-S02 oil-air lubrication system is suitable for the equipments having 30 – 180 lubricating points.
2) Equipped with pneumatic pump or gear pump, one for use and the other one for standby, pump is running as set cycle .
3) After the proportional distribution in the progressive distributor, the lubricant will reach the oil-air mixer block,
4) compressed air and the lubricant are mixed to form a gas-liquid two-phase mixture flow
5) the oil-air flow is transmitted to the primary oil-air distributor & the secondary oil-air distributor in equal or proportion quantity.
6) then to each lubricating points.
There is almost no restriction on density and clarity of lubricating oil in oil-air lubrication system. Ordinary new oil can be used directly. In general,ISOVG220#—320# extreme pressure gear oil or synthetic oil are recommended to clients.



