Model:GAS-2000
Send Inquiry
GAS-2000
Spray-Work Compressor
Power Requirement: 110V AC, 60Hz or 220V AC, 50Hz
Compressor: 1/8HP, Electrical current 0.6A
Capacity: 2.0 cfm
Packing : 5 pcs/1.75 cu.ft/G:21 kgs
**(AIR BRUSH IS NOT INCLUDED)
FACTORS RELATE TO ADEQUATE AIR FLOW:
| 1 | A hose of excessive length and / or insufficient diameter can restrict the air flow. |
| 2 | If you are using an air tool on a hose over 25 ft (7.6 M). long, it is advisable to increase the bore of the hose to the next larger size available, ie. 1/4” increase to 3/8”. This will ensure adequate pressure and volume of air to power the machine. |
| 3 | Usage of air inline filter / regulator |
| 4 | Total number of air connections / fitting being used |
| 5 | Prevent any blockage of air flow. Maintain adequate air flow. |
| 6 | Remove or reduce condensation from the air supply. |
| 7 | Regular check for leaks in all piping, joints, drains, relief valves, flexible hoses. |
| 8 | Water in the compressor tank will cause serious corrosion to your air tools and should be drained daily to avoid excessive water in your air supply. Dirty wet air will rapidly shorten the life of your air tools. |
| 9 | Supply tool with 90 psi (6.2 bar) of clean, dry air. Higher pressure drastically reduces tool life. |
| 10 | Do not install a quick coupler directly into the tool throttle handle. |
| 11 | Prevent contaminates from entering the air motor. |
| 12 | Every day before use, remove the tool from air line and pour 20 cc suitable motor lubricating oil into Air Inlet. Run the tool for few seconds to allow air to circulate the oil and well lubricate the cylinder. This will ensure top performance and maximum durability of tool. |
| 13 | Lubrication : Use an air line lubricator with SAE#10 oil, adjusted to 2 ~ 3 drops per minute. If an air line lubricator can not be used, add air motor oil to the inlet before and after use. Gears, bearing, sleeves, and sliders need to be lubricated as well. |
| 14 | Dissemble and inspect air motor and governor assembly every 3 months if the tool is used every day. Replace damaged or worn parts. |
| 15 | Use original factory supplied tools, spare parts and accessories. |
| 16 | Do not alter or modify the unit from the Original design or function. |
