Model:BR10MA
Br10MA Water heat exchanger specification
can replace Alfa Laval
1.The Heat base Situation in Iron and Steel Industry
It Cost the large energy in iron and steel industry, Iron and steel manufacturing process produces will bring a lot of heat: hot air, Off Gas, Steam. These heat will absorb by building,Equipment,Cooling water,Cooling Oil and so on, The they require the heat exchanger. In iron and steel Factory, And 50% of removal of heat is below 300 Degree C. most of heat removal is below 100 Degree C.
2.The Plate heat exchanger Application in Iron and steel industry
The plate heat exchanger application in iron and steel industry is same as power plant. It included the Close circulating water cooler and Oil cooler. Widely used in mold cooler, Boiler water Cooler, Emulsion cooler, Hydraulic oil Cooler, Ammonia solution Cooler, Coking factory water Cooler and so on.
3.Technology Data
| Unit(mm) | Standard | GB16409-1996 | Design pressure (MPa) | 1.0/1.6/2.5 |
| Design temperture | NBR | -20~110 | Test pressure (MPa) | 1.3/2.1/3.25 |
| EPDM | -50~150 | Maximun surface area of unit | 40 Square | |
| FTP | -20~180 | Maximun flow rate(m3/h) | 225 | |
| F26(FPM) | -55~230 | Jonit pipe | DN100 | |
| 2.Main parameter of plate | ||||
| size of external form | 870x370 | Corrugating deepness | 3.9 | |
| Diameter of corner hole of plate | φ100 | Hydraulic diameter | 7.8 | |
| size of the centre distance of plate | 719X223 | Wave figure | figure | |
| normal pitch in corrugating | 14 | angle | B=56° | |
| 3.Material of plate | AISI304/316/316L Ti Ect. | |||
| 4.Gasket Material | NBR EPDM TP F26(FPM) |
| ||
4.How does Heat exchanger work
1)countercurrent or counterflow: Two media flow "counter" to each other,in opposite directions. One media enters at the top, flows through every other channel, then leaves at the bottom.The other media enters at the bottom,flows through the remaining channel,then leaves at the top.
2)Single Pass design:The two media pass each other only once within the heat exchanger.Single pass designs for the majority of plate heat exchanger,but multi-pass designs are common.
3)Multi-pass design: Two media pass each other more than one time within the heat exchanger. normally is two-pass design.
5.Basic Anatomy for PHE
6.Application
The plate heat exchanger is widely used in HVAC,Petroleum and Chemical,Power,Iron and steel industry,Food and Drug,New energy resources,Auto and Ship.
