A revolutionary design gave birth to a new PANCAKE machine characterized by its compact size, reliability, simplicity, and an easy automatic cleaning machine system.

The Katayef dough, stored in an isolated and refrigerated tank, will be delivered and  sprayed  using an electro-pneumatical actuated volumetrique system, on a rotating food grade steel table heated by a gas coils.

The dough will be automatically pulled from the table and will be delivered to cooling conveyer*.

The machine produce a wide range of dough from 6cm to 15cm of diameter and with a production capacity ranging from 7 to 80 pieces per minute.

Characteristics:

-A Stainless steel isolated and refrigerated tank, automatically delivers the dough to a

volumetrique electro-pneumatical system combined to PLC, optical sensors and

Electronically actuated valves, where the dough will be sprayed on the heated table.

-The machine gives the possibility of high production speed using a sequential shift

between the numbers of operating valves which result a remarkable higher production

speed on small pieces.

- heat resistant food grade steel table and heated with multiple gas coils.

-Each coil can be undependably controlled and regulated using a manual gauge.

-The motor and the electronic parts are completely isolated using a stainless steel

isolated plate covered with rock-wool  that result a higher operating life and remarkable

gas saving.

-The frame is made by stainless steel tubes.

-The dough pieces will be automatically pulled out form the table using Teflon blade

and then automatically delivered on stainless steel net.

-The machine equipped with built in electrical panel with a protection degree IP 65.

-Low Voltage control: 24V.

- Programmed for back- wash where the machine will automatically clean itself.

-  The control panel is fitted with:

1-          Digital display for production speed monitoring and displays warnings and fault

messages.

2-          Flashing light that signals faults or warning.

3-          Rotating knobs for digitally controlled production speed.

4-          Life time counter for production monitoring.

5-    Automatic back-wash knob.