1. Features:
Dimension: 1, 200 x 26.3mm
LED quantity: 116 pieces
Viewing angle: 120
Luminous flux (typical): 1, 600lm
LED forward current: 60mA
Power factor: >0.9
Total power consumption: 26W
Equivalent to fluorescent tube: 40W
Color temperature:
White: 6, 500 to 7, 000K
Warm white: 3, 500 to 4, 100K

2. Description:
Comes in aluminum alloy material with acrylic cover
Available for 100 to 150V, 60Hz and 190 to 260V, 50Hz
277V version is also available
Built with dedicated LED driver with PWM constant current supply to ensure longer operating life and to minimize brightness deterioration due to over-driven, unlike many other designs where only normal rectifier and simple RC circuit is employed
Any individual LED failure will not cause other LEDs in This is an added advantage over other designs
Direct plug-in replacement for conventional T8 fluorescent tube
With electrical or magnetic ballast and starter
Note that it does not need such ballast, starter to operate and normally its performance should not be affected, if left intact
However, for these models with HB LEDs and higher power factor value
Recommended to bypass the magnetic ballast if there is negative impact on PF value or blinking
Not recommended for fixtures with electronic ballast/starter due to much higher voltage
Internal wiring of such fixture must be reconnected to have the electronic ballast/starter removed
Application areas: Suitable for room, hotel, office, supermarket, and commercial building.