Uses of the product
The single-phase filter capacitor is used for the transmission and distribution networks so as to conduct the reactive power compensation, to improve the power factor and to reduce line loss. Thus, it can better the quality of the power by building up a filter which limits the harmonics with the filter reactor and the resistor.

Voluntary Standards for the product
GB/T 11024.1-2001 The AC power system with the nominal voltage which is above 1kV uses shunt capacitor.
Part 1; General Principles
Performance, Test and Rated Value-safety Requirements-Installation and Operation Guides

IEC 60871-1; 1997 The AC power system with the nominal voltage which is above 1kV uses shunt capacitor.
Part 1; General Principles
Performance, Test and Rated Value-safety Requirements-Installation and Operation Guides

THE MODELS OF PRODUCTS
A AM 11/ 1.7 - 334 - 1W
Endnote, Endnotes with W --to be used outdoors, endnotes without W??to be used indoors;
Phase, 1 means single-phase, 3 means three-phase;
Rated Capacity( kvar per unit);
Rated voltage, (kV per unit);
Code of dielectric, AM stands for full-film dielectric M/DBT( or C101), FM stands for full-film dielectric PXE;
Series code, A stands for filter capacitor;
Picture of Filter capacitor per unit; (The original layout of samples)the test report of the type AAM 11/1.7 -334-1W;
One piece of single-phase double casing;
One piece of single-phase single casing.

Main technical parameters
Rated capacity; 100-667 kvar
Rated voltage; 1-20 kV
Rated frequency; 50/60Hz
Solid dielectric; BOPP Films for capacitors
Impregnant; M/DBT or C101; PXE
V Capacitance deviation; Bandpass; -5%~+10%; Qualcomm; 7.5%
Kok loss tangent values; ??0.0003 or ??0.0005 (with the fuse and the discharge resistor)