1. Wirelessly control on/off function

2. The group1 allows dimming and brightening of Z-Wave dimmers if associated

The TKB Z-Wave wall switch is switching attached loads and is controlled either by the local switching paddle or remotely via the Z-Wave wireless protocol

It is included and controlled in a Z-Wave network by a remote control, a wireless control centre or any other kind of Z-Wave controller including a PC-software.

Widely used for smart home and home automation

Introduction

This Wall Mounted Switch is designed to work with other Z-Wave enabled devices. Z-Wave nodes of other types can be added to the system and will also act as repeaters if they support this function of repeating the signal received to other modules in the system.

As part of a Z-Wave network, the TZ66S will also act as a wireless repeater to insure that commands intended for another device in the network are received. This is useful when the device would otherwise be out of the radio range of the wireless controller.

The group1 on the TZ66S allows dimming and brightening of Z-Wave dimmers if associated.

Technical Data

Power: 230 VAC, 50 Hz

Signal (Frequency): 868.42 MHz

Maximum Load Resistive: 6 AMPS (1380 watts) maximum, 230 VAC

Range: Up to 30 meters line of sight between the Wireless Controller and /or the closest Z-Wave Receiver Module.