King Power super fuel max increase combustion efficiency for a cleaner burning engine, this reduces harmful emissions while increasing engine performance.
Super kink size.
500% powerful than normal fuel savers.
Easy to install
Suitable for big house use & industrial use purpose
Designed special for heavy duty vehicle, mobile machinery shop & military equipment.
Super fuel max is a magnetic frequency resonator. By way of its patented Neodymium super conductors it generates the specific resonance frequency that, when installed over the fuel line, will fracture the hydrocarbon chains in the passing fuel. No magnet, no matter how large, can produce the required flux pattern, and yet be small enough in size to fit virtually all installations. Theoretically, when fuel molecules get exposure to the specific resonance created by Neodymium, combustion becomes more efficient, translation: Fuel is burned more thoroughly while un-burned pollution (in the form of exhaust) is reduced.
HOW DOES King Power super fuel max WORK?
Untreated Fuel molecules tend to clump together due to attraction between molecules with charges of opposite polarities. This causes an inefficient burn. As a result, your engine experiences loss of power, lower gas mileage and lots of carbon build-up. Powermags powerful magnetic field causes these clumps of fuel molecules to be charged with a single polarity, thus they repel each other making the fuel disperse more efficiently causing more complete combustion and power production. Turbomag will actually remove the existing carbon build-up in your engine - this usually takes an average of 3 tanks full of gas, followed by a dramatic increase in gas mileage and horsepower.
Since our Super fuel max is New in the market, we dont have any customer feedbacks on it yet but because of our success on our first generation Turbomag fuel saver we have decided to built a better and bigger model. These following testimonials from our first generation Turbomag Fuel Saver
Installing Super fuel max.
1. Locate the fuel supply line under pressure feeding the engine from the fuel tank. Vehicles with fuel injection engines normally have two lines running parallel between the fuel tank and the engine, a supply line and a return line. While the engine is running, feel the lines and the colder one of the two will be the supply line.
2. Insert the nylon tie through the grooves that have the tie retainer slot. This is to help hold the tie in position while applying the Powermag to the fuel line.
3. Simply place the Super fuel max over the fuel supply line, at the accessible location as close to the carburetor or fuel injection system as possible. However do not install the King Power super fuel max in close proximity to the alternator or any electromagnetic energy source. Installation on a metal line has given the best performance. In some cases there has been somewhat less effectiveness on plastic and rubber. We believe better radiation can be achieved through the metal; While we have had good positive results on all materials, if you can, choose a metal fuel line even if it is a connector before the carburetor etc. Do not install the device on braided metal fuel line. This should be replaced for base metal, rubber or plastic fuel pipe.
4. Align the Super fuel max halves so as the side grooves are alike. Complete installation by wrapping the tie completely around the Super fuel max making sure the tie fits into the side grooves. Trim off the excess tie. Check again whether the halves are vertically as well as horizontally alike.
