Installation Steps:
Firstly, Remove the BMW Audio Meter instrument glass and bottom shell.
Secondly, Cut off the center column needles with the electric heating wire one by one.
Thirdly, Please take the dial off, then take the remainder of the needles' transparent plastic columns out carefully.
Fourthly, Remove the old Instrument panel wire, then clean both ends of it. (Note: only can be cleaned with alcohol)
Fifthly, Cut a small triangular hole out with a small knife carefully. Then install the new Instrument panel wire alignment to the original location
Finally, Heat the Article adhesive evenly with T-iron to make cable-fused and then load it after cooling.

Features: Easy of installation, Longer service life, Put to use Immediately after installation