★.Machine introduction:

1. Main technical parameters

(1).Max. paper coverage area:1270×2600mm

(2).Effective printing area:1270×2400mm

(3). Min paper area:350×500mm

(4).Max. printing speed:60 sheets/min.

(5). Economy printing speed:50 sheets/min.

(6).Adapted paper board: three layers, five layers, seven layers.

(7).Chromatography precision: ≤±0.75mm.

(8).Slot precision:≤±1.5mm.

2. Operation instructions of every part of the equipment and the notes.

1. Paper-feeding part: chain feeding.

2. printing part

(1) The drive part of the printing part adopts the big screw and bevel gear drive which increases the strength of the gears and the driving stability under the circumstance of lowering the noise. The material of all the drive gear adopt 45# steel,after high frequency hardening.The paper-feeding of the drive part of the printing part adopts cross sliding drive, which does not enlarge the space between the gear-top and gear-side, make the color process (esp. the multi-color process) more accurate. The gear of all the machine adopt automatic insufflation circular lubricate.

(2) Adopt satellite gear structure for adjust the clockwise and the anticlockwise phase of the printing roller and slotting knife roller.The clockwise and anticlockwise phase of the printing roller and the slotting plate roller adopts 360° electric adjusting while stop working or during working ,it also have function of “clear block memory” and “automatic back to the 0 location”. Electrical adjustment input the data according to the error. The horizontal deriction moveing of the printing roller is adjust by hand, adjusting distance is 10mm.

(3) Each part is electric moving left and right with warning bell. When unit moving, the bell will be warning to make sure the operator safe. The moving motor with constant torsional moment which can buffer the impact of the two units when the operation is wrong. After all the parts closed, each part is pneumatic locked.

(4)The ink distributing of the inking part adopts the rubber roller inking. The anilox roller usually always adopt 180#---240#,also can be chosed accord the customer use.

(5)Inking system adopts pneumatic diaphragm pump inking with the ink cup to prevent the ink splashing. Pneumatic diaphragm pump inking can also adjust the volume of ink.

(6).Pneumatic control up and down of the anilox roller to prevent the print plate two times be inking and to prevent the ink from being dried out and coagulative while short time stopping the machine.

(7).When the machine stop,the anilox roller and rubber roller could running independently for transmission ink and prevent the ink dry out.

(8).There are early warning electric bell and rapid-stop button. In the production process, if there is an emergency, the can press early warning electric bell and rapid-stop button to stop the machine.

3. slotter part

(1)Hand adjust the height of the carton. Four knives are synchronous.

(2) The knife plate and the creasing wheel move left and right is

synchronous adjusted by hand.

(3) The phase adjusting is the same as the printing part.

 
Contact information:cartonmachine@yahoo.cn
MSN:carton.machinery@hotmail.com
www.jdqgjx.cn