The corrugated fastener is one of the many means by which joints and splices are fastened in small timber and boards. It is used particularly in the miter joint. Corrugated fasteners are made of 18- to 22-gauge sheet metal with alternate ridges and grooves; The ridges vary from 3/16 to 5/ 16 inch, center to center. One end is cut square; The other end is sharpened with beveled edges. There are two types of corrugated fasteners: One with the ridges running parallel; The other with ridges running at a slight angle to one another, The latter type has a tendency to compress the material since the ridges and grooves are closer at the top than at the bottom. These fasteners are made in several different lengths and widths. The width varies from 5/8 to 1 1/8 inches; The length varies from 1/4 to 3/4 inch. The fasteners also are made with different numbers of ridges, ranging from three to six ridges per fastener. Corrugated fasteners are used in a number of ways_to fasten parallel boards together, as in fastening tabletops; To make any type of joint; And as a substitute for nails where nails may split the timber. In small timber, corrugated fasteners have greater holding power than nails.