OVER-RUNNING CLUTCH MODULE AND STOCK UNITS

The OVER-RUNNING CLUTCH MODULE at the upper left can be combined with other devices in the users drive. Its low cost along with savings in components and machining results in the most compact and cost effective arrangement possible.  Stock bores are 5/8, 3/4, 7/8 & 1.

 The MODULE WITH BEARING HUB
 at the lower left is dimensionally interchangeable with other clutches of this type. Components such as gears, sprockets, belts, cams etc are mounted on the hub and the entire package is supported
through the hubs plain bearing by the shaft.

The MODULE in the center is supplied with a TANDEM MOUNTED SPROCKET and at the upper right is the MODULE with our COUPLING HUB for in line shafts. The clutch at the lower right has a slot in its FACE PLATE  which can engage a fixed pin for use as a backstop or to input motion from a reciprocating source thus functioning as a ratchet or actuator.