Model PGH1
Powerglide Tailhousing

$179.00

This rollerbearing tailshaft housing is designed to fit both the REID Superglide and the stock GM Powerglide transmissions. 5 times stronger than stock, yet weighs only 4-1/2 pounds

• Bolt in replacement - length and crossmember mounting flange is exactly the same as stock
• Needle roller bearing transfers maximum horsepower
• Triple lip seal
• Spiral retaining ring to prevent bearing walk
• Relocated vent puts an end to the problem of trans fluid spraying out of breather
• Completely pre-assembled
• Includes a hardware kit with everything you need to bolt it on

Special Note: No speedometer cable provision is supplied and due to the precise dimension of the needle bearing, some yokes may need polishing to fit correctly. Accepts 1.497" - 1.499" O.D. yokes. Some yokes are produced at 1.502" to compensate for bushing wear. MEASURE YOURS!

(800-525-1963) offers a yoke especially made for this housing, properly sized with a hardened wear area. M.W. p/n 39035.

We also stock the yoke, Model PGYMW for $219.00

Strange Engineering (847) 869-7010 also offers a special Yoke for the REID Racing PGH-1 tail