I Product Feature:
(1) Operation mode: It locks when the power is off, it opens quickly and push the door of cabinet automatically when it is electrified;
(2) Profile size: 92mm X 33mm X 30mm) and weight of about 150g;
(3) Electrical performance: Operate voltage is DC12V to DC15V, current is 1A at DC12V, duty cycle is 25%, power on time is one second, max. Is less than five second, insulation class is F class, allowed pull force is 500KN(about 50 kg);
(4) Model: WGL-L2010;
(5) Urgent manual unlocking: Built-in urgent unlocking function, so it provide a way of manual open the lock in urgent occasion or wire broken or control device has fault;

(6) Energy saving: It needs only less than one second to electrify when it unlocks. It does not need electricity when it is locked(voltage12V,
(7) Operation life: Reppetitive operation at duty 25%(on 1 second and off 3 second) for one million times can guarantee that the coil does not burn down.
(8) Status output: There are a relay signal(COM, NO and NC)output of the lock's states, which is used to detect the state(open or closed) of the door;
(9) Ways of installing: It can be fixed on beside, top or bottom of the cabinet directly, Embedded and hidden installation are also possible;
(10) Security and stabilization: It is anti-vibration and against unclenching.

It can also be used in finance, military and so on.
II instruction of usages and installation:
(1) Users should read this instruction booklet carefully to check if the major attachment are included. First connect the devices once according to the electric circuit wiring diagram before installing(simulation). Install it again after the lock work normally;

(2) The lock mainly consists of the hook and lock body, Please adjust their moderation while installing. Being smooth and flexible is the better condition;

(3) There are three wires for status output on side, they are used to detect the state of the door; Another two wires on rear is used to control lock open or closed; Status output is relay signal, the black wire means the common point (COM), The yellow wire is normally open (NO), and the red wire is normally closed (NC); Control input is DC12V(up to DC15V) power signal, Usually, red wire is connected to DC12V, and black wire is connected to GND, but exchange connction is available.